ВайФай.РФ о Senao Ubiquiti UBNT Планшетные компьютеры Fujitsu HP Dell wifi сети

Сортировать статьи по: дате | популярности | посещаемости | комментариям | алфавиту
16-09-2017, 14:25

UAP-AC-HD mounting best practice/help

Категория: UniFi

hello folks,

looking for suggestions on where to mount my access point it's a UAP-AC-PRO I was thinking of mounting it on a wall in my hallway but I'm not sure if that is the best location for signal or should it be mounted to the ceiling which is better ? I was thinking the hallway because it's halfway between the family room and the bedrooms but also keeping in mind I have a split foyer home and I have a second floor which is where the family room and the bedrooms are located . I am more concerned about signal on that floor than the basement because that's where we use the wireless the most. if I need to I can get another one to put in the basement if needed because I do you have wiring going to the basement. so with all that said is mounting the access point in the hallway a bad idea or a good idea that would be halfway in the middle of the second floor
16-09-2017, 14:25

UAP-AC-M - does not support zero handoff / mobility ???

Категория: UniFi

Hi, I had a look at the manual upfront and the UAP-AC-M is NOT listed NOT to support mobility/zeo handsoff.

I have updated to the latest firmware to latest 3.8. 

I specifically bought them to get this feature. But the Wlan Group I have created for Mobiltiy are not listed.

What I am doing wrong?

16-09-2017, 14:25

Mesh Pro has non connected clients

Категория: UniFi

i have one mesh pro on a remote site and the controller is saying there non connected users. 
if i shutdown all AP's in around the the Mesh pro the clients on the near AP's dont show up at the Mesch Pro.

the are still non connected client on the controller. 

 

16-09-2017, 14:25

Custom SSL Location

Категория: UniFi

I have to replace my SSL certs on the controller with newer certificated but cannot seem to get it to work. It says it imported to the keystore and yet the old cert still exists. Even after i have deleted the /var/lib/unif/keystore file and rebooted (windows admin habit). Are the certs cached somewhere else also?

16-09-2017, 14:25

UAP-AC-M - clients dont get ip addresses, while a UAP-AC v2 and a UAP-AC Outdoors do

Категория: UniFi

UNIFI Controller:  5.5.20

On the same physical port configurd the same/ a trunk passing the ap vlan and the cleints vlans.

UAP-AC-M - clients can t get ip from DHCP

 

UAP-AC outdoors - clients get ip from DHCP

UAP-AC v2 - clients get ip from DHCP

 

Whats different about the UAP-AC-M

 

16-09-2017, 14:25

AP AC LR "No devices found"

Категория: UniFi

I use the UniFi Controller (5.5.20) with Windows 10. If I deactivate the Windows firewall the AP is found.

Is there a how-to, how the Windows firewall must be configured.

As Router I use an ER-X (UBNT Discovery is deactivated). The AP is connected on eth4 PoE passthrough.

 

Thanks in advance!

16-09-2017, 14:25

FlowControl for UAP-AC-Pro Gigabit Links?

Категория: UniFi

hi,

 

am i right, that flow control on gigabit links to uap-ac-pros doesn't make any sense? or should this be enabled on the switch (cisco) too for the ports were uap-ac-pros are connected?

 

thx!

 

best regards,

 martin

16-09-2017, 14:25

UAP-AC-HD Secondary Port?

Категория: UniFi

So i did some reading on here and it appears the UAP-AC-HD has a secondary port but its purpose is just to pass data traffic (passthrough) to another device without POE. 

 

However my question is this, how does this access point achieve the 1733Mbps transfer rates or even the burst rates of 2533mbps it talks about if the port on it is only rated for 1Gbps? I was thinking you can do a port channel and tie the two ports together as one port and have a 2Gbps connection back to the switch, is that possible to configure? Otherwise how does it achieve these speeds with the bottle neck being the switch port? Not knocking the WAP at all its a great device i am new to it so im trying to figure that piece out if its possible to do that if not i move on and it is what it is until wireless ax comes out Man Happy

16-09-2017, 14:25

Unifi AC Long Range AP outside

Категория: UniFi

Hi,

 

We are about to buy two 5 pack Unifi AC Long Range APs, as we dont have the budget to  buy the PRO version.

 

8 of the AP locations will be internal, however 2 will be outside for our Hotel, however the 2 outside will be 100% undercover and protected from any possible water.

 

Is it possible to use 2 x Unifi AC Long Range APs for our Hotel outside (protected) use even though the LR versions are meant for internal placement?

 

 

16-09-2017, 14:25

UniFi AP cleints no internet access

Категория: UniFi

I have a unifi AP connected to an edgerouter x sfp. Everything worked perfectly until the power went out in the house. When power came back on wireless clients could connect and access the lan but they get no internet access. I have no vlans running and the setup worked perfectly until a reboot. I have rebooted the router and the AP multiple times. From the AP I can ping 8.8.8.8 all my clients receive dhcp address from the edgerouter x and dns seems fine. All wired devices work perfectly fine. Any suggestions?
 
zzz